Epoch Batteries -(PRE-ORDER) 12V 100Ah Eco Series LiFePO4 Battery - ETA SEPT 14

(PRE-ORDER) 12V 100Ah Eco Series LiFePO4 Battery - ETA SEPT 14
 
 
IP 54 Weatherproof
4500+ Cycles
Advanced BMS
Safe & Reliable
LiFePO4 Chemistry - Deep Cycle Battery
Group 24: L10.25" x W6.75" x H9.00"
Low-Temperature cut-off (Charge Protection)
Built-in Smart Battery Management System (BMS)
Advanced BMS system with 20+ safety features built in
Over charge and over discharge protection
Over current and short circuit protection
High & low temperature disconnects
Max (4) in Series up to 48V
Max (16) in Parallel up to 20.48 kWh
4,500+ Cycle life & Maintenance-free
6 Year Manufacturer Warranty
Configuration
Cell Configuration: 4S1P
Chemistry: LiFePO4
Current
Ah Capacity: 100
Max Continuous Discharge Amps: 100A
Max Charge Current Amps: 100A
Max Discharge Peak Current Amps: 300A (5 Seconds)
Series | Parallel: Max (4) in Series, Max (16) in Parallel
Voltage
Voltage: 12.8V
Max Charge Voltage: 14.6V
Operating Voltage Range: 10.0 - 14.6V
Temperature
Charge Temp Range: 0°C (32°F) / 55°C (131°F)
Discharge Temp Range: -20°C (-4°F) / 60°C (140°F)
Weight: 21 (LBS)
Dimensions
Length: 10.25 (inches)
Width: 6.75 (inches)
Height: 9 (inches)
To properly charge your Epoch Batteries, you will want to verify that any charging component in your system is capable of being programmed for the following specifications. Charging components can include, but are not limited to converters, inverter chargers, solar charge controllers, DC to DC chargers, etc.
Bulk/Absorption: 14.2V – 14.6V
Absorption Time: Two batteries in parallel connections require 30 minutes 200Ah
Float: 13.4V – 13.8V
Equalization: 14.4V/ Disabled
Temperature Compensation: 0/Disabled
Charge Rate: 50% of the battery or battery bank capacity
Battery Charge Temperature Range: 32°F (0°C) to 131°F (55°C)
Battery Discharge Temperature Range: -4°F (-20°C) to 140°F (60°C)
Cell Charge Temperature: 32°F (0°C) to 131°F (55°C)
NOTE: Not all chargers are capable of multistage charging. If yours is not, you will want to verify it can be programmed for the Bulk/Absorption voltage and have the other items mentioned disabled if applicable. Consult your charger's manual or the manufacturer.